Steel Set Screw manufactured in the USA

Grip screw is Swiss CNC machined to accept the internal adjustment set screw.

Gunsmith fitting recommended but not required.

Included in package:
**(1) Internally Threaded Grip Screw with Trigger Adjuster Set Screw Installed
**(1) Star Washer
**(1) 5/64 Hex Key for install
(Only (1) Hex Key is included per 3pack of trigger adjusters)


Directions for Assembly:

***BE SURE THE FIREARM IS UNLOADED BEFORE PROCEEDING***
Separate the upper receiver from the lower receiver.
Cock the hammer back and set the safety lever to safe. THE LOWER MUST BE ON "SAFE" TO ADJUST CORRECTLY. Completely remove the set screw from the adjuster.
Apply Blue Locktite to the set screw.
Re-Install set screw to original position with hex head.
Remove original grip screw. Make sure not to lose the safety spring & detent!
Place adjuster into grip and tighten thoroughly with a 3/16" Hex Driver
Tighten set screw using 5/64 Hex Key stops: do not tighten past stopping point.
At this point the safety lever won't move or will be hard to move. Leave on safe.
Back the set screw out 1/8 turn at a time until the safety lever moves freely again.
Function test the lower checking that hammer, trigger, and safety are all functioning correctly. This is as far as you can adjust the adjuster. Let the loctite dry overnight.

These directions are intended to aid a qualified gunsmith in installation.

Grip screws may have cosmetic blems on the machined screw-head but will be functionally perfect. Grip screws include the instructions, Extra-Long Allen Key, and Star Washer.