|
At long last the CZ dovetail scope rail is available in a mount just for the CZ rifle. Produced from high quality 6061 aircraft aluminum on computer controlled milling machines. Mil spec hard anodized for a long lasting finish. Attaches easily with the six(6) supplied set screws. No drilling or tapping required.
Adds approximately .220" to the receiver height
- Installation Instructions:
- Follow ALL NRA safety rules!
- On some model rifles you may need to remove the bolt(see owners manual). Align the Mount up with the dovetail slots and slide the Mount onto the receiver. Center the Mount over the ejection port, install the 2 center screws closest to the ejection port and tighten using a 1/16" allen wrench until they make contact with the top of the receiver. Apply a small amount of blue LocTite(242) or simillar to the 4 remaining set screws. Thread the 4 out board set screws in until they all start to touch the top of the dovetail, and then tighten each one about 1/8 turn(6in lbs) more. Remove the 2 set screws near the ejection port and apply a small amount of LocTite on each and re-install. Let the Mount set for 24hrs before putting the firearm to use.
- Make sure you have the correct part for your application. The supplied chart from CZ is not 100% accurate. Please measure the width of your dovetail at the widest point:
|
