Gunsmith fitting recommended but not required.
Included in package:
**(1) Internally Threaded Grip Screw with Trigger Adjuster Set Screw Installed
**(1) Star Washer
**(1) 5/64 Hex Key for install
Directions for Assembly:
***BE SURE THE FIREARM IS
UNLOADED BEFORE PROCEEDING***
- Separate the upper receiver from the lower receiver.
- Cock the hammer
back and set the safety lever to safe.
THE LOWER MUST BE ON "SAFE"Ć‚Ā¯ TO ADJUST CORRECTLY.
- Completely remove
the set screw from the adjuster by turning the Allen Key CLOCKWISE.
- Apply Blue Loctite
to the set screw.
- Re-Install set
screw to original position with hex head.
- Remove original
grip screw. Make sure not to lose the
safety spring & detent!
- Place adjuster
into grip and tighten thoroughly with a 3/16" Hex Driver
- Tighten set screw
using 5/64 Hex Key. Do
not tighten past stopping point.
- At this point the
safety lever won't move or will be hard to move. Leave on safe.
- Back the set
screw out 1/8 turn at a time until the safety lever moves freely again.
- Function test the
lower checking that hammer, trigger, and safety are all functioning correctly. This is as far as you can adjust the
adjuster. Let the loctite dry
are intended to aid a qualified gunsmith in installation.The lower receiver must be drilled and tapped all the way through the pistol grip or the trigger adjuster will not be able to thread in completely. Please inspect your lower receiver prior to installation to ensure safe installation.