Grip screw is Swiss CNC machined to accept the internal adjustment set screw.
Gunsmith fitting recommended but not required.
Included in package:
**(1) Internally Threaded Grip Screw with Trigger Adjuster Set Screw Installed
**(1) Star Washer
**(1) 5/64 Hex Key for install
(Only (1) Hex Key is included per 3pack of trigger adjusters)Directions for Assembly:
***BE SURE THE FIREARM IS
UNLOADED BEFORE PROCEEDING***
Separate the upper receiver from the lower receiver.
Cock the hammer
back and set the safety lever to safe.
THE LOWER MUST BE ON "SAFE" TO ADJUST CORRECTLY. Completely remove
the set screw from the adjuster.
Apply Blue Locktite
to the set screw.
screw to original position with hex head.
grip screw. Make sure not to lose the
safety spring & detent!
into grip and tighten thoroughly with a 3/16" Hex Driver
Tighten set screw
using 5/64 Hex Key stops: do
not tighten past stopping point.
At this point the
safety lever won't move or will be hard to move. Leave on safe.
Back the set
screw out 1/8 turn at a time until the safety lever moves freely again.
Function test the
lower checking that hammer, trigger, and safety are all functioning correctly. This is as far as you can adjust the
adjuster. Let the loctite dry
are intended to aid a qualified gunsmith in installation.Grip screws may have cosmetic blems on the machined screw-head but will
be functionally perfect. Grip screws include the instructions,
Extra-Long Allen Key, and Star Washer.